Original User Manual FUXTEC petrol leaf blower FX-LB133T_rev06
15
11. Start/stop the leaf blower
The device must not be put into operation until you have read this operating manual,
observed all the instructions given and the device has been completely and correctly
installed!
• Only start the device when it is completely assembled.
• Support the device on the ground for starting and hold it firmly.
1. Maintain a distance from flammable materials.
2. Take a safe standing position.
3. Place the device on the ground in front of you
4. Hold the device by the upper bracket with your left hand
5. Grasp the pull starter with your right hand
Starting with cold engine
1. Slide the ON / OFF switch 2 to position 1.
2. Gently press the primer pump below choke lever 5 several times until fuel enters the pump.
3. Push the starting lever 5 (choke) to
4. Pull out the starting cord 7 at the starting handle slowly until resistance is reached.
5. Pull quickly on the start cord and then release it slowly.
Do not pull out the starting cable completely and do not let the starting handle snap back
on the engine.
6. Push the starting lever (choke) to approx. 20-30sec. after the engine has
started
7. The engine rotates in idle speed
8. Before starting work, let the appliance warm up at idle for about 2-3 minutes and slowly start to
pull the throttle lever 2.
Stop the engine
1. Release throttle stick 2.
2. Set the ON / OFF switch to position 0
Starting with a warm engine
1. Move ON / OFF switch 2 to position 1.
2. Push the start lever (choke) to
3. Pull the starting cord on the starting handle until the engine starts.
To Next Page
Loading...
Need help?
General
