Gallagher W310 v2 - Weighing Static Loads - Fine Mode; At the End of the Weighing Session

3E2362WeighScaleW310v2UserManual

 Page27

Weighingstaticloads‐finemode
1. TurnthemodeselectswitchtoF(Finemode).
2. Ifyouwanttoresetthestatisticsdisplaytozero,pressthe 
button.
FormoreinformationrefertoClearingthestatistics(p24).
3. Checkthattheweightdisplayediszero.Ifitisnot,checkthatnounwanted
objectsarerestingontheweighingplatform,thenpressthebluezero
button.
Note:
The icondoesnotdisplayinFinemode.
4. Placetheloadontotheplatform.
5. Recordtheweight.
6. Pressthegreenweighbuttonifyouwanttoaddtheweighttothestatistics.
7. Iftheweighthaslockedon,butyouwanttore‐weightheload,pressthe
greenWeighbutton.TheWeighScalere‐weighstheloadandlocksthe
weightagain.Thenewweightreplacestheoriginalweightandthestatistics
areupdated.
Weight‐on‐scalememory
TheWeighScalerememberstheweightonthedisplayatthetimeitisswitched
off.Thisweightisrestoredifthesameweightisontheplatformatthetimethe
WeighScaleisswitchedbackon.
Forexample,ifyouareusingFinemodetoweighwoolinabaleonawoolpress,
youcanpart‐fillthebaleandthenturntheWeighScaleoffattheendoftheday.
ProvidedtheloadisstillontheWeighScale,thisweightisrememberedwhen
youreturnthefollowingdayandswitchtheWeighScalebackon.
Asyouaddto
thebale,theweightincreases,fromtherememberedweightattheendofthe
previousday.
Attheendoftheweighingsession
1. SwitchtheWeighScaleoffbyturningthemodeselectswitchtothe 
position.
2. Disconnecttheloadbarcables.
3. Fittheprotectivecapstotheloadbarcables.
4. FittheprotectivecapstotheWeighScale.