Handlebar Mount Instructions
WARNING
See the Important Safety and Product Information guide in the
GPS device product box for product warnings and other
important information.
Mounting the Bracket Assembly
1
Select a location on your handlebars
À
for the mount.
2
Place the head of each screw
Á
in each slot
Â
on the back
of the mount.
3
With the mount on the handlebars, thread the screws through
the mount bracket
Ã
.
4
With the rough end on the outside, tighten the nuts
Ä
by
hand until the mount is secure.
NOTE: Do not over-tighten the nuts.
Installing the Device in the Mount
1
Place the bottom of the device into the cradle
À
.
2
Using the security screw tool
Á
, tighten the security screw
Â
on the top of the mount.
Removing the Device from the Mount
1
Loosen the security screw.
2
Press the button
À
on the side of the mount to release the
device.
3
Tilt the device forward, and lift it out of the mount.
2 Installation Instructions
To Next Page
Loading...
Need help?
General
