Installing or Removing the Fishfinder
1. Connect the wiring harness to the back of the Fishfinder. Make sure the locking ring is fully tightened.
2. Slide the Fishfinder into the pocket (Figure 3). It might be necessary to apply some pressure when inserting the assembly into the pocket to
compress the foam rubber pads. When the Fishfinder is fully inserted, the lock tabs click into place (Figure 4).
3. To remove the unit from the pocket, press the lock tabs toward the unit while sliding the unit out of the pocket (Figure 5).
Figure 3
© Copyright 2006 Garmin Ltd. or its subsidiaries
Garmin International, Inc.
1200 E 151st Street, Olathe, Kansas 66062 U.S.A.
Tel. 913/397.8200
Fax. 913/397.8282
Garmin (Europe) Ltd.
Unit 5, The Quadrangle, Abbey Park Industrial Estate, Romsey, SO51 9AQ U.K.
Tel. 44/0870.8501241
Fax. 44/0870.8501251
Garmin Corporation
No. 68, Jangshu 2nd Road, Shijr, Taipei County, Taiwan
Tel. 886/2.2642.9199
Fax. 886/2.2642.9099
Part Number 190-00582-02 Rev. A
Figure 5
Figure 4
Lock Tabs
To Next Page
Loading...
Need help?
General
