11
Using Your Remote, cont.
3. Press and release the MUTE button.
4. Press and release the VOL - button.
The red indicator light will blink twice
and go off.
Code Identification
1. Press and hold the SETUP button
until the red indicator stays on
(approximately2seconds)andthen
release the button.
2. Press and release the desired device
button (TV, CBL, DVD, AUX) you would
like the code for.
3. Press and release ENTER button.
4. Press and release the #1 button.
Count the number of times the remote
light flashes. This is the number
corresponding to the first digit of the
code. Repeat the process by pressing
the #2, #3 and #4 buttons for the
remaining digits.
5. Press and release ENTERbuttontoexit
this mode.
Reset to Factory Settings
1. Press and hold the SETUP button
until the red indicator stays on
(approximately2seconds)andthen
release the button.
2. Press and release the MUTE button.
3. Press and release the number #0
button. The red indicator light will flash
twice.
To Next Page
Need help?
General
