(on some models)
Your icemaker will produce
eight cubes per
cycle—
approximately 100 cubes in a
24-hour period, depending on
freezer compartment temperature,
room temperature, number
of door
openings and other use conditions.
If your refrigerator is operated
before water connection is made
to the icemaker, keep the icemaker
feeler arm
in the STOP (up) position.
lcemaker\
~
~
Fee
Ier
arm in
position
When the refrigerator has been
connected to the water supply,
move the feeler arm to the ON
(down) position.
The ice cube mold will
automatically fill with water after
cooling to freezing temperature,
and first cubes will normally
freeze after several hours. When
cubes are solidly frozen, they will
be ejected from the mold into the
ice storage bin by means of a
sweeper arm. “
Icemaking will continue until the
feeler arm rests on the ice cubes in
the storage bin. For maximum ice
storage, level the stored cubes with
your hand occasionally. Be sure
nothing interferes with the swing
of the feeler arm.
The icemaker ejects cubes in
groups of eight and it is normal for
several cubes to be joined together.
Once your icemaker is in
operation, throw away the first
few batches of ice cubes. This
will flush away any impurities in
the water line. Do the same thing
after vacations or extended periods
when ice isn’t used.
Move the icemaker feeler arm to
the STOP (up) position when:
● Home water supply is to be off
for several hours.
● Ice storage bin is to be removed
for a period of time.
● Going away on vacation.
If ice is not used often, old cubes
will become cloudy and taste stale
and will shrink. Empty the ice
storage bin periodically and
wash it in lukewarm water.
If this is your first icemaker,
you’ll hear occasional sounds
that may be unfamiliar.
They are
normal icemaking sounds and are
not cause for concern.
Caution:
Under certain rare
circumstances, ice cubes
may be discolored, usually
appearing with a green-bluish
color. The cause of this unusual
discoloration is apparently due
to a combination of factors such
as certain characteristics of
local waters, household
plumbing and the accumulation
of copper salts in an inactive
water supply line which feeds
the icemaker. Continued
consumption of such discolored
ice cubes may be injurious to
health. If such discoloration is
observed, discard the ice cubes
and contact your GE Factory
Service Center or an authorized
Customer
Care@
servicer.
Water Filter Accessory
REMOVES ODORS
Activated charcoal granules
remove musty, stale odors.
IMPROVES TASTE
Activated charcoal granules
remove oily, medicinal, plastic
and metallic tastes.
REDUCES SCALE
Special crystals reduce hard
scale deposit formation.
The water filter is an option at extra
cost and is available from your GE
fiber cartridge catches dirt,
dealer. Specify
WR97X0214.
It has
rust particles, sand and silt.
complete installation instructions
and installs in minutes on 1/4”
O.D.
copper water line.
Water Supply Kit
A kit containing copper tubing,
shut-off
\’alve,
fittings and
instructions needed to connect the
icemaker to your cold water line is
available at extra cost. See
Preparation section.
Icemaker Accessory Kit
If your refrigerator did not come
already equipped with an automatic
icemaker, an Icemaker Accessory
Kit is available at extra cost.
Contact your local GE dealer and
specify Kit
IM-
1.
7
—
To Next Page
Loading...
Need help?
General
