Installation Instructions
[] PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the
wall. Push the refrigerator back to the wall.
START THE ICEMAKER
On power switch models, set the icemaker power
switch to the ! (on) position. On feeler arm models,
move the feeler arm to the ON (down) position. The
icemaker will not begin to operate until it reaches
its operating temperature of 15°F (-9°C) or below.
It will then begin operation automatically.
Powerswitchmodel
STOP(up)position
FeelerArmin
theON(down}position
Feelerarm model
NOTE: In lower water pressure conditions, the
water valve may turn on up to 3 times to deliver
enough water to the icemaker.
[] REVERSING THE DOOR SWING
IMPORTANT NOTES
When reversing the door swing:
• Read the instructions all the way through befbre
starting.
• Handle parts carefully to avoid scratching paint.
- Set screws down by their related parts to avoid using
them in the wrong places.
" Provide a non-scratching work surface for
the doors.
IMPORTANT: Once you begin, do not move the
cabinet until door-swing reversal is completed.
These instructions are for changing the hinges from
the right side to the left side if you ever want to change
the hinges back to the right side. follow these same
instructions and revm*e all references to left and right.
TOOLS REQUIRED
Phillipsscrewdriver Maskingtape
5/t6'<hex-head
socketdriver
T20or T25Torxdriver,
wNc.heveryour model
requires
Putty knife or thin-
blade screwdriver
5/t6" open:end
wrench
19
To Next Page
Loading...
Need help?
General
