To Next Page

To Previous Page

Consumer Support

Troubleshooting Tips

Operating Instructions Safety InstructionsInstallation Instructions

Refrigerator Lights

CAUTION: Light bulbs may be hot.

Unplug the refrigerator.

To remove the light shield, grasp the

shield at the back and pull out to

release the tabs at the back.

Rotate the shield down and then

forward to release the tabs at the front

of the shield.

After replacing with an appliance bulb

of the same or lower wattage, replace

the shield.

Plug the refrigerator back in.

NOTE: Appliance bulbs may be ordered

from GE Parts and Accessories,

800.626.2002.

Freezer Light

Replacing the light bulbs.

Turning the control to the 0 (off) position does not remove power to the light circuit.

Appearance may vary

CAUTION: Light bulbs may be hot.

Unplug the refrigerator.

The bulb is located at the top of the

freezer inside a light shield. To remove

the shield, grasp the shield at the back

and pull out to release the tabs at the

back.