14
3. Press FLASH/PROGRAM again to store your selection. You will hear a
conrmation tone.
Ringer Level
NOTE: This setting may only be made with the base.
1. Press the FLASH/PROGRAM button until SET RING LEVEL shows in the display. 1HI
is the default setting.
. Press 1, or 3 on the base touch-tone pad to enter your selection, or use the
REVIEW or NEXT button to scroll to your selection.
3. Press FLASH/PROGRAM again to store your selection.
NOTE: If you turn the ringer OFF, RINGER OFF shows in the base display.
Ringer Tone
NOTE: This setting may be made on both the base and the cordless
handset, independent of each other.
You may choose from three different ringer tones.
1. Press the FLASH/PROGRAM button until SET RINGER TONE or RINGER TONE shows
on the display. The default ringer tone is 1.
. Use the touch-tone pad to select 1, , 3 or use the REVIEW or NEXT button on the
base unit or VOL/CID (- or +) button on the handset to scroll to your selection. The
ringer tone plays for few seconds.
3. Press FLASH/PROGRAM again to store your selection. You will hear a
conrmation tone.
Tone/Pulse
NOTE: This setting may only be made with the base.
Most telephone systems use tone dialing, however, some may still use pulse dialing.
Depending on your telephone system, set the dialing mode as follows:
1. Press the FLASH/PROGRAM button until SET TONE/PULSE shows on the display.
The default setting is 1TONE.
To Next Page
Loading...
Need help?
General
