22
ANSWERER
Problem Explanation/Solution
Doesn’t answer, or answers on 10th ring. • Make sure answerer is turned on.
• Memory is full, erase some messages.
• Check AC power and phone line connections.
Incoming messages are incomplete. • Was an extension phone picked up?
• The caller left a message that is longer than the
message length you set during setup.
• Memory is full.
Won’t respond to remote commands. • Must use touch-tone phone.
• Must enter correct security code.
• Did unit hang up? If you take no action for a
period of time, it automatically hangs up.
Answerer doesn't work. • Unplug power cord from the electrical outlet
and plug it back in to reset the answerer.
NOTE: If the battery is not installed, this next step
will erase all your messages and return the unit to
the default settings.
• If that doesn’t work, unplug the power cord
from the back of the unit and plug it back in.
This is a complete reset.
Can't hear messages. • Adjust volume control.
Unit announces
“Battery Low”.
• Install a new 9-volt alkaline battery.
Can't restart message. • You must play message for at least 5 seconds
before pressing REVIEW button.
To Next Page
Loading...
Need help?
General
