11
CLEANING AND MAINTENANCE
Self-cleaning
• This function removes scale and mineral build-up in the steam chamber.
• Fill the iron to half its capacity with water ( Filling iron with water).
• Connect the power plug (11) to a suitable electrical outlet.
• Slide the function control (5) to the dry ironing
position (ill.
g
).
• Press the temp. button (4) on either side of the iron until the cotton-linen indicator
(14)ashes(ill.
d
).
• Place the iron on its heel (10) and let it heat up (ill.
e
). The cotton-linen
indicator (14)ashesuntiltheselectedtemperaturehasbeenreached.
• After the cotton-linen indicator (14) lights up steadily, press the temp. button (4)
(ill.
d
) until the o indicator (18) lights up. Disconnect the iron from the electrical
outlet.
• Slide the function control (5) to the steam ironing
position (ill.
h
).
• Hold the iron over a sink with one hand, and press and hold the self clean
button (19) continuously with the other hand. CAUTION: Boiling water with steam
and impurities is ejected from the soleplate nozzles (21).
• Gently move the iron back and forth.
• Release the self clean button (19) when the water tank (20) is completely empty.
Cleaning the iron
• Do not use harsh abrasives, chemical cleaners or solvents to clean the casing of
your iron, as these will damage its surface.
• To clean the occasional build-up of scale on the soleplate (21) and the casing, just
wipe with a soft damp cloth.
• Always store the iron in an upright position on its heel (10) (ill.
e
).
Storage
• Before storage, make sure to turn the iron o and empty the water tank (20)
( Turningironoandemptyingwatertank).
• Let the iron cool and dry completely.
• Store the iron in a dry and cool place. To avoid accidents, ensure that both the iron
and its power cord (11) are beyond reach of children or pets.
898693-Iron-EN-04.indd 11 2/9/12 4:58 PM
To Next Page
Loading...
Need help?
General
