To Next Page

To Previous Page

K0554 Revision A 1

1 Introduction

This manual is applicable to ADTS542F/552F/553F and 554F, referred to as ADTS, and

provides safety and installation information for the Air Data Test Set, compatible with

the requirements of first line operation.

A touchscreen (ADTS Touch) is used to control all required functions. The ADTS Touch

can be positioned on the ADTS or used as a hand held mobile unit via a cable or

Bluetooth

® wireless technology. This allows a person to complete the entire test

program remotely while conveniently seated in the aircraft. The ADTS Touch can be

powered when positioned on the ADTS, or using a cable connection to the ADTS or

battery powered.

The manufacturer has designed this equipment to be safe when operated using the

procedures detailed in this manual.

For details of calibration requirements for the ADTS, refer to User Manual K0553.

For details of available manufacturer specified parts, refer to the current revision of the

product data sheet.

Service/maintenance and repair will be carried out at GE authorised service centres.

1.1 Intended use

Test and calibration of aircraft aeronautical pressure instruments located indoor in a

hanger or calibration laboratory or outdoor on a runway, refer to User Manual K0553

for further information.

WARNING

THIS EQUIPMENT IS NOT RATED FOR USE IN POTENTIALLY EXPLOSIVE

ATMOSPHERES. USING THIS EQUIPMENT IN A POTENTIALLY EXPLOSIVE

ATMOSPHERE COULD LEAD TO SERIOUS INJURY OR DEATH.

If the equipment is used in a manner not specified by this document and K0553 the

protection provided by the equipment may be impaired.

1.2 Safety

Examine all equipment to be used, paying particular attention to electrical leads and

connectors and pneumatic pipes and connectors. DO NOT use any equipment that is

known to be or suspected to be damaged or faulty.

1.3 Power supply

1.4 Power supply connection

Do not apply electrical power outside the values stated.

Make sure that the power supply is off before connecting the power cable.

Single phase

110/230 VAC, 50/60Hz

200 VA MAX

115 VAC, 400Hz

GE ADTS542F Safety And Installation Guide

Other manuals for GE ADTS542F