GE AEV07KP Use & Care Manual

Operation Procedure
10
4
TEMP/TIMER BUTTON
Press the ▲ to increase the set (operating) temperature of the unit.and Press the ▼ to decrease the set
(operating) temperature of the unit. The temperature seting range is from 16~30°C (61~86°F). Press the
▲ also to increase the selected time, and Press the ▼ to decrease the selected time. The time setting
will be modified in steps of half an hour at a time when less than 10 hours, and in steps of an hour for
more than 10 hours.
The time seting range is from 0.5~24 hours.
5
SIGNAL RECEIVER
6
MODE BUTTON
Select the operation mode FAN, COOL, AUTO.
7
ENERGY SAVER BUTTON
Under energy saving mode, lamp of energy saving mode is on, and the temperature setting range is
16~30°C (61~86°F). The buzzer will give out a beep if remote control turbo speed by remote controller
NOTE:
Control panel is capable of displaying temperature in degrees Fahrenheit or degrees Celsius, To convert
from one to the other, Press and hold the Up ▲ and Down ▼ buttons on Control panel together for 3
seconds.
OPERATION OF REMOTE CONTROL FOR ELECTRONIC MODEL
Delay 0.5-24hr
Delay timer
Decrease
Mode select
Fan speed
Decrease
Temperature
set Increase
and Decrease
Delay timer Increase
Auto Fan on
Fan speed Increase
Unit power on/off
Remote Control
1
Power Button
Turns air conditioner on and off. When turned on, the display will show the room temperature.
2
Display
Shows the room temperature or time remaining on the Delay timer. Shows the Set temperature while
setting the temperature except Auto mode.
NOTE:
The display will change to show the room temperature after settings have been made. To change the
Set temperature, press the Temp Increases ▲ or Decrease ▼ buttons

GE AEV07KP Specifications

General

Brand	GE
Model	AEV07KP
Category	Air Conditioner
Language	English