~
Fabric Care Selections
Push a button to select the proper heat for your load.
Should be used with cycles indicated ●
Automatic,
Fabric Care
Automatic
Perm Press and
Timed
Selections
Regular Cycle
Knits Cycles
Cycles
—
Cottons
High Heat
●
●
Perm Press
Medium Heat
●
●
Knits/Delicates
Low Heat
●
●
Fluff
●
I
No Heat
@
Extra Care
Cvcle
@
Select End of
Cycle
Signal, if
(~perates
only
w[th
Automatic,
desired. (See below)
Perm Press& Knits Cycles.)
Turn to ON if desired. To minimize
@Turn Cycle Selector to desired
cycle setting. The selector may be
writies
set in the clothes, the Extra
Care cycle provides approximately
turned in either direction.
15 minutes of no-heat tumbling
~Press
PUSH TO START button
after the clothes are dry.
to start dryer. (Opening the door
Use End-of-Cycle Signal. Signal
during operation stops the dryer. To
will sound at five-minute intervals
re-start, close the door and press
to remind you to remove the clothes.
the START button.)
What is the difference
between
~med
&
Automatic drying?
Timed Drying
When using the TIMED
~CLES,
you select the number of minutes
you wish the dryer to run and it
turns off at the end of this time
period.
Automatic Drying
When using the Automatic Cycles,
the
Electronic Sensor Control
system
continually senses the
moisture in the tumbling clothes,
determines when they are dried to
your pre-selected setting, and
terminates the cycle automatically.
Refer to the CONTROLS SETTING
GUIDE for recommended settings.
The Cycle Selector will not advance
until clothes have reached a
ce~in
degree of dryness.
Dryness selections guide for
the automatic cycles
End-of-Cycle Signal
(Operates with any cycle.)
I
Variable Signal
@
OFF
LOUD
The Signal control can be set
anywhere between OFF and
LOUD, depending on desired
sound level. The signal will sound
just before the end of the cycle to
remind you to remove the clothes.
To stop signal while sounding, turn
Signal control to OFF or advance
Cycle Selector to OFF.
The Signal
should
always be used
when drying Polyester Knits or
Permanent Press items which
should be removed as soon as the
dryer stops to help prevent setting
of wrinkles.
The signal should also be used with
the Extra Care Cycle.
Polyester
Kniti
&
Permanent Press
drying tips
● DO NOT
OVERLOAD—
Garments being dried or
dewrinkled should tumble freely.
● REMOVE
CL~HES
PROM~LY—To help prevent
wrinkling, remove from the dryer
promptly at the end of the drying
cycles.
● PLACE ON
HANGERS—
Permanent Press and Polyester
Knit garments
look
best if placed
on hangers after drying.
5
Set to Middle Position
,,,
s
Auromer,
c
,,””
Reguler
cycle
...,
*
,,.”
/
(Q
..~;i+’
.,,’
● For most normal loads.
Set
toward
MORE DRY
●
For loads that include heavy-
weight fabrics.
●
If you desire to remove more
moisture.
. For lightweight fabric loads.
●
If you desire to remove less
moisture.
●
For very small loads.
To Next Page
Loading...
Need help?
General
