Operating instructions.
Throughout this manual, features and appearance may vary from your model.
CZD
• Add fabric softener to the fabric • Loosely add items around in.fusorTM. , Select wash cycle.
softener dispenser; see page 7. Overloading may neqatively impact , Select wash options,
• Add detergent. GE recommends wash performance. _ee page 8 for including Fabric Softener
the use of High Efficiency _ suggested loading examples, option.
detergents in all Energy , Close lid. , Select options including
Star-rated washers. NOTE: Washer will not fill with lid Pretreat/Bleach option.
open.
Unlock Lid
Power
Step 4
, Press Start.
Press to "wake up" the display. If the display is active, press to put the washer into idle mode.
NOTE: Pressing POWERdoes not disconnect the appliance from the power supply.
Start and Unlock Lid
PressStart to begin the cycle.NOTE:Thelid must be closed for the washer to fill and the cycle to start. If the lid is open,"UD" will scroll across
the display. If the lid isclosed,the lid will lock, the LID LOCKEDlight will light,the detergent will be dispensed, and "FILL"will scroll across the
display.
PressingUnlock Lid will Pause the cycle and the Start indicator light will blink.
To continue the cycl< press Start again. If machine ispaused more than 2/4hours, the cycle will becancelled. If water remains in the machine,
selectthe Drain & Spin cycle to drain tub and spin water out of the washer tub.
Display and Status Lights
Display:
The display shows the approximate time remaining until the end of the cycle.
NOTE:Thecycle time isaffected by how long it takes the washer to fill.This depends on the water pressure inyour home. The "smart" timer
"learns" the amount of time it takes to fill your washer and adjusts the total time accordingly.
In addition, this display will, "scroll" the washer status:
bALANCINg Start of rebalancing cycle to redistribute clothes. Stops after rebalancing iscomplete.
CYCLEPrEP Sensingdry load size prior to fill (normal).
• dELAY When Delay Wash is initiated. Replaced with estimated time when cycle starts.
End Endof current cycle.
ES Washer in a delay start (4 hour maximum) awaiting lower energy rates (seethe Energy Smart section).
FILL Forthe first/45 secondsof a fill,the estimated end of cycle time is displayed. Forthe rest of the fill time, "FILL"isscrolled
until the fill completes.
H20 SUPPLY Can not sense water level (valvespossiblyturned off).
HEAt Water being heated for Sanitize cycle.
• Lid Cyclestopped because lid isopen. Closethe lid.
LOAdSenSE Sensingwet load size(normal).
PAUSE Cyclepaused because the StardPause button was pressed and the washer was set to Pause. PressStart button again to
restart the cycle.
Cyclestatus lights:
Showswhether the washer is inthe SOAK,WASH,RINSEor SPINcycle.
Feature status lights indicate (seesections F,G and Hfor more details):
V The My Settings feature ison for this cycle.
6 Thewasherislocked-willblinkonceifyoupressanybuttonorturnthecycleknob. _ Thelidislocked. SeetheControlLockdescription.
_1_))Thesignal is on. Seethe Variable Signal description.
The eWash feature is selected.
EnergysmartTheEnergy Smart feature isselected. SeeAbout Appliance Communication section. _ A Delay Wash time is set.
To Next Page
Loading...
Need help?
General
