49-3000087 Rev 1 23
Raise
Lower
Installation Instructions
FINAL SETUP
NOTE: Stacking installations may require a power
cord up to 6 feet in length.
Power
LEVEL THE DRYER
Stand the dryer upright near the final location and
adjust the four leveling legs at the corners to ensure
that the dryer is level from side to side and front to
rear.
PLUG DRYER IN
1
2
DRYER START-UP
Press the Power button.
NOTE: If the dryer has been exposed to temperatures
below freezing for an extended period of time, allow it to
warm up before pressing Power. Otherwise, the display
will not come on.
The dryer is now ready for use.
3
Disconnect power supply before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical
shock.
- Electrical Shock Hazard
WARNING
Ensure proper
ground exists
before use.
To Next Page
Loading...
Need help?
General
