GEAppliances.com
Wash Cycle Selector
Thewash cycle controls the length and intensity of the washing process.Theknob can be turned in either direction. Turning the
CycleSelector knob after starting a cycle will stop the washer and reset the cycle to the new selection, PressStart to begin the
new cycleselection.
Thechart belowwill helpyou match the wash cycle setting with your clothing.The chart is ranked from longestto shortest cycle
time and wash intensity. (Cyclesvary by model.)
Power Clean - Usesmore water than standard wash cycles.It isrecommended for extra-large loads and heavily soiledclothes.
Cottons - For heavy to lightly soiled cottons, household linens, work and play clothes.
Permanent Press - For wrinkle-free and permanent press items, and knits.
Oelicates - For lingerie and special-care fabrics with light to normal soil.
Quick Rinse - Rinsesand spins non-soiled items where a rinse only is desired.
Spin Only - For draining the tub and spinning water out of clothes.
Off- Washer isturned off and the Start button does not function.
NOTE:When the control is turned to OFF,the Status lights are off.
NOTE:Thecycle selector does not rotate during the operation of the washer.
Deep Rinse
Setthis option when adding fabric softener to the washer.
I Status lights
The Status lights show the stage the washer is in.When the selector knob isset to a new cycle, the Status lights will
flash momentarily, showing the stages the cycle will go through.
Status light Illuminates
On When the fabric softener option has been selected.
Wash When the washer is in the wash portion of the cycle.
Rinse When the washer is in the rinse portion of the cycle.
Spin When the washer draining and/or spinning.
When the washer lid is locked. This feature prevents the lid from being opened while the
Lid Locked
washer is in the spin cycle or coasting to a stop.
NOTE: If the Status lights are blinking, the operation of the washer has been paused. To resume operation
press the Start button (the lid must be closed).
Temperature
Select the water temperature for the wash cycle (all rinses use cold water). Always follow fabric manufacturer's care
label or instructions when laundering.
Tap Cold* uses incoming tap water, which can provide energy savings. For all other temperature selections, a mixture
of hot and cold water is used to achieve the ideal temperature for each temperature setting.
*Please note that some detergents do not fully dissolve in very cold water. If you experience this, it is
recommended you choose a setting other than Tap Cold.
Load Size
Looselyload clothes no higher than the top row of holes inthe washer basket.
Auto Load Sensing- Thisselectionautomatically providesthe correct amount of water suited to the sizeand type of load
placed inthe unit.
Start
PressStart to begin the cycle.With the lid closed pressingStart again will pause the cycle and Status lights will blink.To
continue the cycle,close the lid and press Start again. The water fill will continue with the lid opened, except when Auto Load
Sensing isselectedas the load size.(Thelid must be closed to continue filling when Auto Load Sensing is selected.)
Ifthe lid isopened during the cycle,the cycle will pause and the Status lightswill blink.Toresume the cycle,close the lid and
press Start.
Ifthe machine is paused for more than 2z_hours,the cycle will be cancelled.To stop the cycle,turn the CycleSelectorto the
Off position.
To Next Page
Loading...
Need help?
General
