15
Troubleshooting Tips
Water not hot enough
or cold enough
Dispenser is unplugged. Push the plug completely into the outlet.
The fuse is blown/circuit breaker is
tripped.
Replace house fuse or reset the house circuit breaker.
Problem Possible Causes What To Do
All the water in the water tank has
been used.
Wait 30 minutes for water to heat or cool.
Temperature limiter tripped. Set the cold and hot power switches to the 0 (off)
position. Wait five minutes, then set the switches to
the I (on) position. wait 30 minutes for water to heat
or cool.
Water dispenser
does not work
Empty water bottle. Replace with a new water of bottle.
Mineral deposits clogging tanks. See Care and Cleaning.
Water dispenser
leaks from the
outside
Crack or pinhole in bottle.
Water dispenser is
noisy
Water dispenser is uneven. Make sure the water dispenser is installed on a level
floor or counter strong enough to support it when
fully loaded.
Bottle making a gurgling noise as
water fills the tanks.
This is normal.
Replace with a new water of bottle.
Technical Specifications of Your Water Dispenser
Inlet Tension or
Nominal Tension (Volt)
Operation Frequency or
Nominal Frequency (hertz)
Nominal Power (Watt) or
Nominal Current (Ampere)
115 V ~
4,7 A
60 Hz
To Next Page
Loading...
Need help?
General
