GE GXRM10G User Manual

Reverse Osmosis Cartridge—The cartridge, inside
the Reverse Osmosis housing, includes a tightly
wound, special membrane. Water is forced through
the cartridge where the membrane removes the
dissolved solids and organic matter. High quality
product water exits the Reverse Osmosis housing
and goes to the storage tank. Reject water, with
the dissolved solids and organic matter, leaves the
housing and is discharged to the drain through
tubing.
Postfilter—After leaving the storage area,
but before going to the system faucet, product
water goes to the postfilter which is inside the
sump. The postfilter is also a replaceable
sediment cartridge that contains activated
carbon. Any remaining tastes, odors or
sediments are removed from product water
by the postfilter. Clean, high quality drinking
water flows through the tubing and to the
system faucet.
System Monitor— A timer is provided in the faucet
base to remind you when it is time to replace
your prefilter and postfilter. Replace the filters
when the blue light begins to flash in order to
protect the RO membrane and keep the system
functioning properly. Be sure to remove and
replace the battery at the same time to reset
the timer.
Flow Control—The flow control regulates the flow
of water through the Reverse Osmosis cartridge
at the required rate to produce high quality
water. The control is located in the Reverse
Osmosis housing drain port. A small, cone-
shaped screen fits over the front end of the flow
control to prevent clogging due to sediments in
drain water. The flow control and screen should
be replaced each time the Reverse Osmosis
membrane cartridge is changed.
15
www.GEAppliances.com
Screen
Flow control
1/4″ black tubing
(to drain)
Consumer Support
Troubleshooting Tips
Operating InstructionsSafety Instructions Installation Instructions

GE GXRM10G Specifications

General

Brand	GE
Model	GXRM10G
Category	Water Filtration Systems
Language	English