Installation of the range.
Read these instructions completely and carefully.
Before You Begin
IMPORTANT: Save these instructions for the local electrical
inspector’s use.
IMPORTANT: OBSERVE ALL GOVERNING CODES AND
ORDINANCES.
NOTE TO INSTALLER: Leave these instructions with the
appliance after installation is completed.
NOTE TO CONSUMER: Keep this Owner’s Manual and
Installation Instructions for future use.
NOTE: This appliance must be properly grounded.
■ Large blade screwdriver
■ 1/4″ hex head nutdriver
■ Channel lock pliers or small ratchet wrench with 3/16″ socket
(for leveling range)
Tools You Will Need
Electrical Requirements
CAUTION, FOR PERSONAL SAFETY: DO NOT USE AN
EXTENSION CORD WITH THIS APPLIANCE.
REMOVE HOUSE FUSE OR OPEN CIRCUIT BREAKER
BEFORE BEGINNING INSTALLATION.
This appliance must be supplied with the proper voltage and
frequency, and connected to an individual, properly grounded
branch circuit, protected by a circuit breaker or time delay fuse,
as noted on the rating plate.
Wiring must conform to National Electric Codes.
If the electric service provided does not meet the above
specifications, have a licensed electrician install an approved outlet.
Because range terminals are not accessible after range is in position,
flexible service conduit or cord must be used.
Troubleshooting TipsInstallation Instructions Customer ServiceOperating InstructionsSafety Information
27
To Next Page
Loading...
Need help?
General
