12
Installation Instructions
Pub. No. 31-10473
229C4053P452
PRE-TEST CHECK LIST
E
Remove all protective film if present,
and any stickers.
Check to be sure that all wiring is
secure and not pinched or in contact
with moving parts.
Check that the bottom trim is installed
properly (see page 10).
Check to be sure the mounting screws
are installed and flush with the side
trim, (see page 10).
Operation Checklist
Remove all items from the inside
of the oven.
Turn on the power to the oven.
(Refer to your Use and Care
Manual.) Verify that the bake and
broil units, and all cooking
functions operate properly.
Check that the circuit breaker is
not tripped or the house fuse is
blown.
Check that conduit is securely
connected to the junction box.
See Use & Care manual for
troubleshooting list.
NOTE TO ELECTRICIAN:
The power leads supplied with this
appliance are UL recognized for
connections to larger gauge
household wiring. The insulation of
these leads is rated at temperatures
much higher than the temperature
rating of household wiring. The
current carrying capacity of a
conductor is governed by the wire
gauge and also the temperature rating
of the insulation around the wire.
NOTE: ALUMINUM WIRING
A. WARNING:
IMPROPER CONNECTION OF
ALUMINUM HOUSE WIRING TO
THE COPPER LEADS CAN
RESULT IN A SERIOUS PROBLEM.
B. Splice copper wires to aluminum
wiring using special connectors
designed and UL approved for
joining copper to aluminum and
follow the manufacturer’s
recommended connector
procedure closely.
NOTE:Wire used, location and
enclosure of splices, etc., must
conform to good wiring practice
and local codes.
To Previous Page
Loading...
Need help?
General
