GE JKP26 User Manual

QUESTIONS?
USE THIS PROBLEM SOLVER
PROBLEM
“F- AND A NUMBER”
FLASH IN THE DISPLAY
OVEN WILL NOT WORK
OVEN
LIGHT
DOES NOT WORK
FOOD DOES NOT
BROIL PROPERLY
FOOD DOES NOT ROAST
OR BAKE PROPERLY
CLOCK AND
MINUTE/SECOND
TIMER DO NOT WORK
OVEN WILL NOT
SELF-CLEAN
DOOR WILL NOT OPEN
AFTER SELF-CLEAN CYCLE
CONTROL SIGNALS AFTER
ENTERING OVEN TIME
OR STOP TIME
OVEN TEMPERATURE TOO
HOT OR TOO COLD
“BURNING” OR “OILY”
ODOR EMITTING FROM
OVEN WHEN TURNED ON
STRONG ODOR
OVEN NOT CLEAN AFTER
SELF-CLEAN CYCLE
“door” APPEARS
IN THE DISPLAY
~•N•••N•Ì•N•••N•°Šb•€•N•¼•N•ø•N•4!N•ÄŠb•¬#N•è$N•$&N•`'N•ØŠb•Ø)N••+N•P,N•Œ-N•ìŠb••0N
POSSIBLE CAUSE
~ This is function error code. Press the CLEAWOFF pad. Allow the oven to cool
one hour. Place the oven back into operation. If function error occurs again,
disconnect power to the oven and call for service.
* The circuit breaker in your house has been tripped, or a fuse has been blown.
● The oven controls are not properly set.
● The light bulb is loose or defective. Tighten or replace.
* The switch operating the mm light is broken. Call for service.
* Oven controls riot set properly. See the Broiling section.
● Door not left open to the broil stop position as recommended.
* Improper shelf position being used. See the Broiling Guide.
● Food is being cooked on a hot pan.
● Cookware is not suited for broiling.
● Low voltage. See the Broiling section.
● Aluminum foil used on the broiler pan and rack has not been fhted properly
and slit as recommended.
● Oven controls not set properly. See the Baking or Roasting section.
* Shelf position is incorrect. See the Roasting or Baking section.
. Incorrect cookware or cookware of improper size is being used.
* Oven thermostat needs adjustment. See the Adjust the Oven Thermostat—
Do It Yourself section.
c Check for a power outage.
● See the Oven Control, flock and Timer section.
● Oven temperature is too high to set self-clean operation.
Allow the oven to
cool to room temperature and reset the controls.
● When the temperature has fallen below the locking temperature,
the door can be opened.
● This is reminding you to enter a bake temperature.
Q Oven thermostat needs adjustment. See the Adjust the Oven Thermostat—
Do Zt lburseZfsection.
● This is normal in a new oven and will disappear in time. To speed the process,
set a self-clean cycle for a minimum of 3 hours. See the Operating the Self-
Cleaning Oven section.
● An odor from the insulation around the inside of the oven is normal for the
first few times the oven is used. This is temporary.
● Oven controls not set properly. See the Operating the Self-Cleaning Oven section.
Q Heavily soiled ovens require 3]%- to 4-hour Clean Time.
● Heavy spillovers should be cleaned up before starting the self-cleaning cycle.
● Oven door not closed after self-clean cycle is selected.
● Door is still locked and you are trying to enter an oven cooking operation.
If you need more help.. call, toll free:
GE Answer
Center@
800.626.2000 consumer information service
26

GE JKP26 Specifications

General

Brand	GE
Model	JKP26
Category	Oven
Language	English