GE JKS10 User Manual

GEAppliances.com
iAWARNING
iA CAUTION
Receotacle
on some moaels
ocep ac OC O
(on some models
SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect the electricalpower to the oven at the main fuse or circuit breaker panel. Failure to do so may result
in electric shock or burn.
i URN HAZARD: The gloss cover and bulb should be removed when cool. Touching hot
gloss with bore hands or a damp cloth can cause burns.
Oven Light Replacement
To remove:
r-f1 Turn the glass cover counterclockwise 1/4
turn until the tabs of the glass cover clear
the grooves of the socket. Wearing latex
gloves may offer a better grip.
r_ using gloves or a dry cloth, remove the
bulb by pulling it straight out.
To replace:
[Z] use a new 120/130-volt halogen bulb, not
to exceed 50 watts. Replace the bulb with
the same type of bulb that was removed.
Your model will have one of the two types
shown on the left.To determine the
correct replacement bulb, check the bulb
terminals. Bulbs with 2 straight pin
terminals are G6.35 bulbs. Bulbs with 2
looped terminals are G9 bulbs. (Do not
interchange.) Be sure the replacement
bulb is rated 120 volts or 130 volts (NOT
12 volts).
BE
Usinggloves or a dry cloth, remove the
bulb from its packaging. Do not touch the
bulb with bare fingers. Oilfrom skin will
damage the bulb and shorten its life.
Receptacle
i
gtovesor
cloth
%
Placethe tabs of the glasscover into the
grooves of the socket.Turn the glass
cover clockwise 1/4 turn.
Forimproved lighting inside the oven,
cleanthe glass cover frequently using a
wet cloth. Thisshould be done when the
oven iscompletely cool.
[] Reconnectelectrical power to the oven.
Pushthe bulb straight into the receptacle
r_ all the way.
:i¸!Q!!i!ii
i u
13½" _ '
, P-\ :
'Bulb,
I
n u
Glasscove[
Oven Light Bulb (onsomemodels)
Toremove:
Turn the glass cover counterclockwise 1/4
turn until the tabs of the glass cover clear the
grooves of the socket. Remove the bulb.
Toreplace:
Putin a new 40-watt appliance bulb. Placethe
tabs of the glass cover into the grooves of the
socket.Turn the glass cover clockwise 1/4 turn.
NOTE:
A 40-watt appliance bulb is smaller than
a standard 40-watt household bulb.
Install and tighten the cover clockwise.
Reconnect electrical power to the oven.
For improved lighting inside the oven, clean
the glass cover frequently using a wet
cloth. This should be done when the oven is
completely cool.
25

GE JKS10 Specifications

General

Brand	GE
Model	JKS10
Category	Oven
Language	English