Installation Instructions
To use toggle bolts:
Mounting
Plate
Spacingfor TogglesMore
+l_-,-i*_ ThanWall Thickness
i
ToggleWings
BoltEnd
[]Place the mounting plate against tile wall and
insert the toggle wings into tlle holes in tile wall
tO H1OtlII[ tile plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the tabs on the mounting plate
touch the bottom of rile cabinet when pushed flush
against the wall and rtlar tim plate is properly
centered under rile cabinet.
CAUTION" Becarefulto avoid
pinching fingers between the back of the mounting
plate and the wall.
[]Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
I-_ USETOP CABINETTEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit ttlrough.
• Read the instructions on the TOP CABINET
TEMPI ,ATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPI,ATE.
CAUTION: Wearsafety goggles when
drilling holes in the cabinet bottom.
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST
_;!_ Remove and save the screw that holds the blower
motor door closed on the back and the blower
retaining screw on the top of the dooL
Blower --_,-_,
Retaining _ jjBIower
Scre
•Blower Motor
_, DoorRetaining
Backof Screw
Microwave
Oven
_Open the blower door it the backby lifting tip
at
of the microwave oven. Remove and save the
blower retaining screw.
/_''" BlowerRetaining
Screw
[ Careflflly the blower unit. The wirespull
otlt
will extend far enough to allow you to adjust the
blower unit.
EndB
EndA
16
To Next Page
Loading...
Need help?
General
