To Next Page

To Previous Page

Helpful Hints

An occasional thorough wiping with a solution of baking soda and water keeps the

inside fresh.

Unplug the cord before cleaning any part of this oven.

How to Clean the Inside

Walls, Floor, Inside Window, Metal and Plastic Parts on the Door

6RPHVSDWWHUVFDQEHUHPRYHGZLWKDSDSHUWRZHORWKHUVPD\UHTXLUHDGDPSFORWK5HPRYH

greasy spatters with a sudsy cloth, then rinse with a damp cloth. Do not use

abrasive cleaners or sharp utensils on oven walls.

To clean the surface of the door and the surface of the oven that come together upon

closing, use only mild, nonabrasive soaps or detergents using a sponge or soft cloth. Rinse

with a damp cloth and dry.

Never use a commercial oven cleaner on any part of your microwave.

Removable Turntable and Turntable Support

To prevent breakage, do not place the turntable into water just after cooking. Wash it carefully

in warm, sudsy water or in the dishwasher. The turntable and support can be broken if dropped.

Remember, do not operate the oven without the turntable and

support in place.

1 2 3

4 5 6

7 8 9

Power

Level

Set

Clock

Turntable

Cook

Time

Timer

On/Off

Add

30 Sec

Clock Display

Express Cook

Sensor Cooking

Defrost

Reheat

Vegetable

PotatoBeverage

Popcorn

Weight/Time

Cancel

Off

Start

Pause

How to Clean the Outside

Do not use cleaners containing ammonia or alcohol on the microwave oven. Ammonia or

alcohol can damage the appearance of the microwave.

Case

Clean the outside of the microwave with a sudsy cloth. Rinse with a damp cloth and then dry. Wipe

the window clean with a damp cloth.

Control Panel and Door

Wipe with a damp cloth. Dry thoroughly. Do not use cleaning sprays, large amounts of soap and

ZDWHUDEUDVLYHVRUVKDUSREMHFWVRQWKHSDQHO³WKH\FDQGDPDJHLW6RPHSDSHUWRZHOVFDQDOVR

scratch the control panel.

Door Surface

It is important to keep the area clean where the door seals against the microwave. Use only mild,

non-abrasive detergents applied with a clean sponge or soft cloth. Rinse well.

Power Cord

If the cord becomes soiled, unplug and wash with a damp cloth. For stubborn spots, sudsy water

may be used, but be certain to rinse with a damp cloth and dry thoroughly before plugging cord

into outlet.

Stainless Steel (on some models)

Do not use a steel-wood pad; it will scratch the surface.

To clean the stainless steel surface, use a hot, damp cloth with a mild detergent suitable

for stainless steel surfaces. Use a clean, hot, damp cloth to remove soap. Dry with a dry, clean cloth.

Always scrub lightly in the direction of the grain.