QS–54 MULTILINK ML1600/2400 ETHERNET COMMUNICATIONS SWITCH – QUICKSTART GUIDE
QUICK START GUIDE
Z Select the Transfer menu item and choose the Send File option.
Z Enter the location of the configuration file and select Xmodem for
the protocol.
Z Click on the Send button.
The file will start to load as shown below:
Z Once the transfer is complete, the switch will have to be rebooted
either by entering Reboot or by switching the power off then on.
ML1600/2400# reboot
Proceed on rebooting the switch? [Y or N] Y
Rebooting now...
Z Once the switch has rebooted, login and verify that the
configuration was loaded correctly.
This completes the upgrade process.
QS.6.4 Updating Using the EnerVista Web Interface Software
Use the following steps to install the EnerVista Secure Web Management software.
Z Download the latest MultiLink firmware from the GE Multilin web
site to a convenient location on your hard drive.
To Next Page
Loading...
Need help?
General
