Before you call for service...
Troubleshootingtips
i!ili!!!iiii
Possible Causes What To Do
Dishesdon'tdry
Controlpanel
respondedtoinputs
butdishwashernever
filledwith water
Dishwasherwon'trun
Low inlet water
temperature
Rinse agent dispenser
is empty
Door latch may not be
properly seated
Fuse is blown, or the
circuit breaker tripped
':_Make sure inlet water
temperature is correct
(see page !2).
<',Select HI TEMPRINSE
and/or HEATEDDRY,
<_Check dae rinse agent
dispenser,
_,Call for service°
'_ Replace fuse or reset
circuit bieaker: Remove
any oflaer appliances from
the circuit.
,: Try resetting the
START/RESETpad,
Steam This is normal
'::Steam comes through
flae vent by dre door latch
during drying and when
water is being pumped out.
Sanitized light does
not illuminate at the
end of the cycle
The door was opened
and the cyde was
interrupted during or
after the main wash
portion
The incoming water
temperature was too low
<:Do not interrupt dae cycle
an)_me during or after
main wash.
'.'_Raise flae water heater
temperature to 120°E
24
To Next Page
Loading...
Need help?
General
