EasyManuals Logo
Home>GE>Control Panel>NetworX NX-8E

GE NetworX NX-8E User Manual

GE NetworX NX-8E
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
8
Ready Light
The ready light is “on” when the system is ready to arm and “flashes” if ready to
force arm. The ready light is off when the system is not ready to arm because
of a zone(s) being faulted.
Stay Light
The stay light is “on” when the all interior (motion detector) zones are
bypassed.
Zone Light
The zone lights are “off” when everything is normal. A zone light will be “on” if
the zone has been bypassed. If a zone light is “flashing”, that zone is in alarm
or has been faulted. If a zone light is “flashing” rapidly, it means that the zone is
in a trouble condition. Trouble conditions are:
Tamper Hardware Low Battery Loss of Supervision
(A combination of Alarm/Fault and Tamper/Trouble will produce a rapid
“flashing” light for a short period of time, followed by a slow “flashing” light.)
EMERGENCY ACTIVATION KEYS
NOTES: You must hold these keys for 2 seconds to activate these
functions. Your system may not be programmed for these activation keys
(see page 1). You should press these keys only in an emergency situation that
requires response by emergency personnel. If your system is programmed for
these functions, the following reports can be sent.
Fire Key – This key can activate the fire alarm when pressed for two seconds. If
your system is connected to a monitoring center, an emergency report could be
sent to that center.
Auxiliary Emergency Key – This key can activate the auxiliary alarm when
pressed for two seconds. If your system is connected to a monitoring center, an
emergency report could be sent to that center.
Police (Panic/Hold-Up) Key - This key can sound a local audible alarm when
pressed for two seconds. If your system is connected to a monitoring center, an
emergency report could be transmitted to that center. NOTE: Some Panic/Hold-
Up alarms are programmed to be silent at the protected site while reporting an
alarm to the monitoring center. Check with your installing company to determine
how your security system will respond to the Panic/Hold-Up activation.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE NetworX NX-8E and is the answer not in the manual?

GE NetworX NX-8E Specifications

General IconGeneral
BrandGE
ModelNetworX NX-8E
CategoryControl Panel
LanguageEnglish

Related product manuals