GE PNSF39Z01 Owner's Manual

Troubleshooting Tips
Review the charts on the following pages first and you may not
need to call for service.
Problem Possible Causes What To Do
Water feels slippery Absence of hardness • This is normal.
after installation of minerals
water softening system
Water softening system
Water softening system • Does not use much salt
not using any salt is a “demand” unit to regenerate—very
efficient.
Possible salt bridge • See the
Care and Cleaning
section.
Possible plugged nozzle • See the
Care and Cleaning
and venturi section.
Water is blue color Acidic water in • Have the water tested
after water softening copper plumbing at once.
system was installed
WARNING:
Do not drink the water until
problem has been corrected.
Water softening system
Meter turbine stuck • Call for service.
not regenerating
Sensor wire corroded • Call for service.
Faceplate defective • Call for service.
No power to unit • Check the circuit breaker
or fuses.
Cloudiness on Combination of soft • This is called etching and
glassware water and too much is permanent. To prevent
(automatic detergent this from happening, use
dishwashers) less detergent if you have
soft water. Wash glassware
in the shortest cycle that
will get them clean.
Salty tasting water Insufficient backwash • Increase backwash time.
after installation and rinse time See the Service:
Regeneration and Heavy Duty
Backwash section.
Low water pressure • Check pressure; should be
minimum 20 psi.
Restricted drain hose • Clean and reconnect hose.
Safety InformationOperating InstructionsTroubleshooting TipsCustomer Service
Before you call for service…
22

GE PNSF39Z01 Specifications

General

Brand	GE
Model	PNSF39Z01
Category	Water Dispenser
Language	English