About the dishwasher control panel
El
El
Start
Close the dislm_Mler door and select the cycle and
desired enhancerrlents. Touch the START/RESETpad to
begin tile cycle. _ter fill begius, and approximately
60 seconds later tile wash action begins.
NOTE."Tile dishwasher l_membel_ t_)ur last cycle so
you don't hme to reprogram each "time. When tile
(lish_M/er door is fidly closed, the control panel
Ilights will dispkg the last settings Fm selected.
Clean
Tile CLEANlig]lt is illuminated \allen a _*sl/rxcle
is complete. The light will stay ON until the d(;or is
opened.
If you don't want to change any of tile setdngs, simply
toilch tile START/RESETpadto begin fl_e Qcle.
If the door is closed the indicaU/r lights will turn
off if the STABY/RESETpad is not selected within t\_o
minutes. To activate tim (lispla_; open and close tile
door or press any pad.
,Ms<),iia power iidlure occm_, NORMALand HEATED
DRYwill automatically lyewogmmmed. Make any new
selecdous and touch the START/RESETpad to begin tile
Cvcle.
Flashingdisplaylights.
StatusIndicatorLights WhatItMeans
START/RESET
Using the dishwasher.
C}cle has been inten'upted b} pressing tile START/RESETpad.i,ight will quit
tlashing after tile dishwasher automatically drains out the watel:
Checkthe Water Temperature
Tile entering water should be at least 120°F and not
reel> than 150°F tbr ettective cleaning and to pre_ent
dish damage. Check tile water tempenmlre with a
candy or l;qeat t]lerl;qol;qeter. TtlrI/Oil tile hot water
faucet nearest tile dishwashen place the thermometer
ill a glass and let tile water run continuously into the
glass until the temperature stops rising.
UseJet-Dry RinseAgent
Jet-Dry_ riuse agent removes spots and pre_ents new fihn buildup on your dishes, glasses, flar\_are, cookware and
plastic.
FillingtheDispenser
Tile rluse agent dispenser holds 24.5oz. of rinse agent. Under normal conditions,
this will last approximately one month. T_) to keep it full, but do not oxerfill.
[_] Make sm_ file dishwasher door is tidly open.
[_ Turn tile dispeuser knob to the let< and liit it out.
[-j] Add linse agent until the indicator windo_, looks fldl.
[_] Clean up any spilled rinse agent with a dmnp cloth.
N Replace the dispenser knob.
window Dispensercap
RinseAid Setting
The amount of rinse agent leleased into tile final _sl/can lye a(!justed. The ti<tory
setting is at the midpoint. If there are rings of calcium (hard _ter' spots on dishes,
try a higher setting.
To adjust the setthlg
Remove tile dispeuser knob; then turn tile a(!juster counterclockx_ise to increase
the al-l-lOilll[of riuse agent.
Dish PreparationPriorto Loading
agent
adjuster
6
• No pl>rinsing of nollnal ff_od soil is l>quired.
• Scrape off hard soils, including bones, toothpicks,
skills, and seeds.
• Remove large quantities of any l>maining filed.
• Remove leai_ vegetables, meat trimmings, and
excessiveamounts of grease or oil.
• Remove acidic ii_odsoils that can discolor stainless
steel.
To Next Page
Loading...
Need help?
General
