18
Installation Instructions
BEFORE YOU BEGIN
After leveling, make sure that doors are even at
the top.
To make the doors even, adjust the refrigerator door.
Using a 7/16″ socket wrench, turn the door
adjusting screw to the right to raise the door, to
the left to lower it. (A nylon plug, imbedded in the
threads of the pin, prevents the pin from turning
unless a wrench is used.)
After one or two turns of the wrench, open
and close the refrigerator door and check the
alignment at the top of the doors.
To remove the base
grille, open the doors,
remove the screw at
each end of the base
grille and then pull the
grille straight out.
7/16″ Socket Wrench
Raise
DOOR ALIGNMENT
To Next Page
Loading...
Need help?
General
