Simon XT System Manual
https://alpha.adt.com/help/64[11/12/2018 9:41:49 PM]
1. Press [DOORS] + [WINDOWS] + [security code] when the panel displays “enter code”.
2. While the panel is in the process of arming, press [MOTIONS].
3. The panel displays “Doors + Windows & Motions”, the [DOOR] + [WINDOW] and [MOTION] button
will light up, and the system will speak “Doors and windows on, motions on”.
4. The panel will begin an "exit delay" and beep until the exit delay expires.
Disarming
To disarm:
1. Press [DISARM], then enter your [code] when the panel displays ‘enter code”.
2. The panel displays DISARM, pees once and speaks “disarmed”
Subdisarm
To subdisarm:
1. Enter the [master code] while the system is disarmed.
2. The panel will display “Subdisarmed”, the DISARM button will blink, and the system will speak
“subdisarmed” and beep once.
EXIT/ENTRY DELAY
Your Simon XT provides a delay after entering or exiting your home before the system is alarmed.
Exit Delay
The exit delay is the amount of time the system gives you to exit the home before the system is armed.
When the user arms the system, an exit delay starts. During the delay the user can vacate the premises
through a delayed response door without causing an alarm.
Silent Exit
The silent exit feature silences the beeps accompanying the exit delay. Press SILENT after you arm the
system to silence the beeps. NOTE: enabling the silent exit doubles the exit delay time.
Entry Delay
The entry delay is the amount of time a system gives you to disarm the system before sound the alarm.
This feature must be programmed by the installer. Some active sensors cause immediate alarms when
tripped. Other sensors, if enrolled in a delayed response group, start an entry delay that lets you enter
the premises and disarm the system. If the system has not been disarmed by the end of the entry delay,
the alarm occurs.
To Next Page
Loading...
Need help?
General
