Electronic Monitor & Diagnostic System
..
It keeps an eyeon
things foryou.
v???
@ Red signal light flashes to tell
you when either door is open.
@G
reen signal light tells you that
the Door Alarm beeper has been
set to sound after either door has
been open 30 seconds.
@Red signal light tells you when
freezer foodkeeping temperature is
above normal.
@G
reen lighted word NORMAL
indicates that no failure has been
detected by the diagnostic system.
@Flashing green diagnostic
codes in the display warn you
when:
❑
frozen foods should be
checked.
H
power has been interrupted.
❑
icemaker may not be operating
properly.
❑
defrost systemhas failed.
❑ freezer control may need to be
set for a colder temperature.
What these codes mean—and
what to do when they appear—is
summarized on the inside of the
freezer compartment door and
explained more thoroughly on
the following pages.
@System Check pad putsa
review of the electronic diagnosis
of five coded functions at your
fingertip and also allows you to
erase codes from display.
@Electronic control allows you
to turn night light in water-and-ice
dispenser on and off.
@Electronic control allowsyou
to select ice cubes or crushed ice,
and green signal light confirms
your choice.
6
When your refrigerator
is first plugged ‘in.. ~
All panel lights come on for five
seconds, a beep sounds, and lights
go off except as follows:
s PF flashes in the display. Touch
SYSTEM CHECK-RESET pad to
erase it.
● Green word NORMAL glows.
● Red WARM TEMPERATURE
light glows if freezer compartment
temperature is higher than normal.
It goes off when proper foodkeeping
temperature is reached.
● Door alarm beeper is activated
$
and green light on DOOR ALARM
pad glows.
● CRUSHED ice selection light
glows.
● Red DOOR OPEN light flashes if
either door is open, goes out when
doors are shut.
● Night light in water-and-ice
dispenser is off.
(continued nextpage) -.
To Next Page
Loading...
Need help?
General
