Cable Tie
Cable Tie
Cable Tie
Laundry Tub
Stand Pipe
WARNING
: Make sure the washer is
unplugged.
Run some water from the hot and cold faucets
to flush the water lines and remove particles that
might clog up the water valve screens.
FLUSH WATER LINES
1
Installation Instructions
WASHER CONNECTIONS - STATIONARY MODEL WSLS1500
Connect the inlet hose ends to the HOT and COLD
water faucets tightly by hand, then tighten another
2
ø3 turn with pliers. Turn the water on and check for
leaks. Retighten if necessary.
CONNECT TO WATER LINES
2
CAREFULLY MOVE THE WASHER
TO ITS FINAL LOCATION
3
Form a U shape on the end of the drain hose with
the hose pointed toward the drain. Place the hose in
a laundry tub or stand pipe and secure it with a cable
tie (not included).
NOTE: If the drain hose is placed in a stand pipe
without forming a U shape, a siphoning action could
occur. There must be an air gap around the drain
hose. A snug hose fit can also cause a siphoning
action.
CONNECT DRAIN HOSE
4
PLUG THE POWER CORD INTO A
GROUNDED OUTLET
5
Ensure proper ground
exists before use
15
To Next Page
Loading...
Need help?
General
