Before Using Your Oven
Be sure you understand how to set the controls properly. Practice removing
and replacing the shelves while the oven is cool. Read the information and
tips on the following pages. Keep this manual handy where you can refer
to it, especially during the first weeks of using your new range.
Oven Control
Your oven is controlled by a single OVEN CONTROL knob.
It will normally take 30-90 seconds before the flame comes on. After the
oven reaches the selected temperature, the oven burner cycles—off
completely, then on with a full flame—to maintain the selected temperature.
Oven Moisture Oven Light
As your oven heats up, the temperature change of the
air in the oven may cause water droplets to form on
the door glass. These droplets are harmless and will
evaporate as the oven continues to heat up.
Use the switch on the lower control panel to turn the
light on or off.
(continued next page)
11
USING YOUR OVEN
Griddle Using Your Oven
To Set the Clock (on some models)
NOTE: When you first plug in the range or after a
power failure, the entire Clock display will light up.
1. Press the SET CLOCK button.
2. Press and hold the + or – button
and the time of day will change
10 minutes at a time. To change the
time by single minutes, give the
buttons short taps.
3. Press the SET CLOCK button to start
the clock.
GEAppliances.com
Power Outage—Electric Ignition
CAUTION: DO NOT MAKE ANY ATTEMPT
TO OPERATE THE ELECTRIC IGNITION
OVEN DURING AN ELECTRICAL POWER
FAILURE. The oven or broiler cannot be lit
during a power failure. Gas will not flow unless the
glow bar is hot.
If the oven is in use when a power failure occurs,
the oven burner shuts off and cannot be re-lit until
power is restored. This is because the flow of gas
is automatically stopped and will not resume when
power is restored until the glow bar has reached
operating temperature.
To Next Page
Loading...
Need help?
General
