Before Using Your Oven
Be sure you understand how to set the controls properly. Practice removing
and replacing the shelves while the oven is cool. Read the information and
tips on the following pages. Keep this guide handy where you can refer to
it, especially during the first weeks of using your new range.
Power Outage—Standing Pilot
An electrical power failure will not affect the
standing oven pilot.
Power Outage—Electric Ignition
CAUTION: DO NOT MAKE ANY ATTEMPT
TO OPERATE THE ELECTRIC IGNITION
OVEN DURING AN ELECTRICAL POWER
FAILURE. The oven or broiler cannot be lit
during a power failure. Gas will not flow unless
the glow bar is hot.
If the oven is in use when a power failure occurs,
the oven burner shuts off and cannot be re-lit until
power is restored. This is because the flow of gas
is automatically stopped and will not resume when
power is restored until the glow bar has reached
operating temperature.
Oven Control
Your oven is controlled by a single OVEN CONTROL knob.
It will normally take 30-90 seconds before the flame comes on. After the
oven reaches the selected temperature, the oven burner cycles—off
completely, then on with a full flame—to maintain the selected temperature.
Oven Moisture Oven Light (on some models)
As your oven heats up, the temperature change of the
air in the oven may cause water droplets to form on
the door glass. These droplets are harmless and will
evaporate as the oven continues to heat up.
Use the switch on the lower control panel to turn the
light on or off.
(continued next page)
11
USING YOUR OVEN
Clock and Timer Using Your Oven
GEAppliances.com
To Next Page
Loading...
Need help?
General
