GEMAŞ Genel Mühendislik Mekanik San.ve Tic.A.Ş.
İTOB Organize Sanayi Bölgesi 10001 Sok.No:28 Menderes/İZMİR TURKEY
Tel:0232 799 0 333 Fax:0232 799 0 330 www.gemas.com.tr info@gemas.com.tr
EN GEMAS PURITRON INSTRUCTION MANUAL V1.8
4.3.Fault Codes and Suggested Solutions
Cable is broken or not touching
Check cable and connection
terminals, replace if necessary.
Check electrode cable connection
terminals.
Clean the lime from the cell and
reduce the polarity period.
Clean the lime from the cell and
reduce the polarity period.
Device output has a short circuit
Check device electrode cable,
electrode connection terminals,
and replace it if necessary.
Contact the manufacturer.
5.WARRANTY - AFTER-SALES SERVICE - SPARE PARTS
1. Control unit and electrode cells are under a two-year warranty.
2. The products are taken out of the scope of warranty by the following items.
a. Malfunctions caused by using the product contrary to the operating instructions.
b. Malfunctions due to incorrect electrical connections.
c. Faults caused by crash and similar accidents.
d. Water malfunctions in the control unit.
e. Faults resulting from operation without a bypass circuit (according to the wiring diagram).
f. Malfunctions caused by acid spillage into the skimmer without shutting down the control unit.
g. Malfunctions caused by insufficient air circulation in the engine room where the acid tank used for
disinfection is located.
h. The Puritron; It must not be in the same environment with cleaning equipment, including pumps, filters,
and multi-way valves.