GEMAŞ Genel Mühendislik Mekanik San.ve Tic.A.Ş.
İTOB Organize Sanayi Bölgesi 10001 Sok.No:28 Menderes/İZMİR TURKEY
Tel:0232 799 0 333 Fax:0232 799 0 330 www.gemas.com.tr info@gemas.com.tr
EN GEMAS PURITRON INSTRUCTION MANUAL V1.8
3.COMMISSIONING - USE
Review the electrical and water installation. Be sure to follow the assembly instructions written above
correctly. If there is no deficiency or error, you can start the commissioning process.
• Open the water inlet and water outlet valves, turn off the bypass valve. Make sure there are no water
leaks in the valves and the chamber.
• Make sure that phase, neutral and ground wires are properly connected. Remember, the device will work
with the pump and shut down with the pump. Open the residual current relay/fuse. Check the supply
terminals with the control pen or gauge.
• Turn on the device using the on / off switch at the bottom of the device. The control screen on the front of
the device will be energized. There will be a closed mode screen on the control screen.
• The generator will work at the factory settings. If you want to change these settings, you can make the
necessary changes with the help of the user guide.
3.1. Control Panel and Settings
1.2x16 LCD screen; information and warnings about the device
are displayed.
2.The device performs the functions of ON / OFF (switching on /
off), entering the setting menu (the device is turned off, pressed
for 3 seconds when it is OFF), and exit the pages and parameters
in the setting menu.
3.Selection of the pages and parameters in the setting menu,
performs the functions of confirming and saving the set
parameters.
During the operation by holding it down for 3 sec., the device
switches to boost mode and runs at full capacity for 8 hours.
4.In the settings menu, it performs the functions of passing to the next page or parameter and increasing the
parameter values.
5.In the settings menu, it performs the functions of switching to a sub-page or parameter and decreasing
parameter values.
3.1.1. Control Panel Operation Screen Icons and Values
1.Cl Production Rate: This section shows the instant CL
production rate. It can be increased or decreased by using
the arrow keys.
2.CL Production and Polarization Icon: 3 different
icons appear in this section:
Correct directional polarization icon.
Reverse directional polarization icon. Operating
in reverse polarization does not harm the device.
The lime cleaning feature on the electrodes is
activated.
No polarization. Cl is not produced. Polarization
change is made.
3.This section shows errors and warnings that affect Cl production. By pressing the OK button once, the
instantaneous current value drawn during production is shown. Detailed information about faults is explained in
the Fault Codes and Suggested Solutions section.
4.It is the part where the instant pH value measured is displayed.
To Next Page
Loading...
Need help?
General
