PAGE 3
2.3 - PA
When this function is programmed, the system passively arms approx. 60” after ignition switch OFF
and after the last door is opened and closed.
System activation is confirmed by the standard optical/acoustic signals.
SSIVE ARMING
If passive arming is enabled, the internal sensors and the comfort output (automatic
window roll-up) are excluded.
Opening a door 60” before the system is armed causes the procedure to interrupt; it is
resumed once the door is closed.
2.4 - ARMING DELAY
The arming delay lasts approximately 30” and is signalled by the LED turned ON steady;
.
it is possible
to exit the vehicle without triggering any alarm
2.5-SYSTEM ARMED
2.6 - ALARM, NEUTRAL TIME BETWEEN ALARMS AND ALARM CYCLES
2.7-SYSTEM DISARMING
2.8 - EMERGENCY DISARMING BY ELECTRONIC KEY
After the arming delay, the system is fully armed and ready to detect any alarm condition. When the
system is fully armed, the LED will start flashing.
An alarm condition is signalled
before another alarm cycle starts, there is a
.
Press the unlock button on the vehicle original remote control.
nrutehtfosehsalf2dnasprihcneris2ybdemrifnocsignimrasiD
indicators.
signals are detailed in .
This disarming
by optical/ signals.
.“5.xorppafo”emitlartuen“tub,dereggirtsimralaehtretfA
An alarm event generates a maximum of ten alarm cycles for each input and for each arming cycle
(if feature has been enabled)
An alarm condition is signalled by5acoustic signals (if feature has been enabled) and 5 flashes of the
turn indicators.
The various alarm causes and relative LED
mode is used for “EMERGENCY DISARMING” and “TOTAL DISARMING”.
Touching the electronic key to its receptable disarms and switches o
ff the system which does not
rearm when the remote control is used.
acoustic
30”
paragraph (2.9)
To restore normal operation, touch the electronic key to its receptacle.
A quick chirp andaflash of the status LED will confirm that the system is back to normal
mode.
To Next Page
Loading...
Need help?
General
