PAGE 4
2.9 - ALARM MEMORY
chirps 5 times (
), it means that an alarm conditon has occured while away from your vehicle
If, when disarming, the turn indicators flash 5 times and the if feature has been
enabled .
The cause that triggered the alarm can be identified by the LED memory.
Turn ignition key “ON”;the vehicle status LED will blink according to the last alarm detected.
Optical signals are repeated 3 times; to interrupt, turn ignition key “OFF”.
The table below lists the various alarm causes and relative LED signals.
siren
last
SESUACMRALASEHSALFDEL
ALARM
CYCLES
10
10
1
10
10
0
10
Ignition attempt (+15/54)
Door opening
Bonnet opening
Boot opening
Volumetric or external sensor
Wire tampering
LED ON (1 second)LED OFF (2 seconds)
3.0-WARRANTY CONDITIONS
This product is guaranteed to be free from manufacturing defects foraperiod of 24 months from the
installation date shown on this warranty, in compliance with the Directive 1999/44/CE.
Please fill-in entirely the guarantee certificate included in this booklet and do NOT REMOVE the
guarantee label from the device.
The warranty will become void if labels are missing or torn, if the installation certificate is not fully
compiled or if the enclosed sale document is missing.
The guarantee is valid exclusively at authorized Gemini Technologies S.p.A. Service Centers.
The manufacturer declines any responsibility for eventual malfunctions of the device or any damage
to the vehicle electrical system due to improper installation, use or tampering.
This alarm system is solely intended to be a theft-deterrent device.
4.0-WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
(WEEE) DIRECTIVE
The present device does not fall within the scope of Directive 2002/96/EC on Waste Electrical and
Electronic Equipment (WEEE) as specified in art. 2.1 of L.D. no. 151 of 25/07/2005.
TECHNICAL SPECIFICATIONS
Power supply
Current absorption @ 12Vdc with system armed and LED flashing
Working temperature
Turn indicators relay contact capacity
Engine immobiliser relay contact capacity
Alarm cycle duration
Maximum positive current output when armed (+A)
Maximum load of siren output
range
12 Vdc
15 mA
-30°C to +70°C
8A@ 20°C
8A@ 20°C
30 sec.
700 mA
1 A
To Next Page
Need help?
General
