Gemini GEM-DXK2 User Manual

11
Disarming the System
1
Upon entry, the keypad sounder will turn on as a reminder to disarm the panel. The
red ARMED light will be on and the window will alternately display "DISARM" and
"XXXSEC", where "XXX" represents the entry time remaining in 10-second steps.
During the final 10 seconds, the sounder will pulse a warning signal.
2 Enter your User Code and press U. The sounder will silence and the red ARMED
light will go out, indicating that the system has been disarmed.
• If you enter an invalid code, the keypad display "Wrong Code" Re-enter your code
immediately.
Alarm Indication / Silencing an Alarm
If the red ARMED light is flashing and “ALARM” is displayed, an alarm occurred while
you were out. Proceed with caution! If you suspect that an intruder may still be on the
premises, leave immediately and call authorities from a neighbor's phone.
To silence an audible alarm:
1 Enter your code and press U. After the system is disarmed, the window will continue
to display “ALARM” followed by the zone(s) violated.
2 To reset the display, note the zones violated, then press C.
TURNING OFF THE ALARM (DISARMING) WHEN RETURNING
AC ON
DISARM/
XXXSEC
AC ON
Wrong/
Code
AC ON
ALARM/
ZONE02

Gemini GEM-DXK2 Specifications

General

Brand	Gemini
Model	GEM-DXK2
Category	Keypad
Language	English