Generac Power Systems 00940-2 User Manual

Generac
®
Power Systems, Inc. 13
Section 3 – Maintenance
IMPACT-36 plus II Recreational Vehicle Generator
3.5 ENGINE AIR CLEANER
Paper Filter: Once every 25 operating hours or once
each year (whichever comes first), clean or replace
the paper filter (Figure 3.3). Follow the steps on page
12.
Figure 3.3 — Engine Air Cleaner Assembly
• Remove air cleaner cover, then remove paper filter.
• Clean air filter by gently tapping it on a solid sur-
face. If the filter is too dirty, replace it with a new
one. Dispose of the old filter properly.
• Clean air cleaner cover then insert new paper filter
into cover and assemble to the base of the air
cleaner.
3.6 CLEAN AIR INTAKE SCREEN
Clean all foreign material from the air intake screen
(Figure 3.4) at lease once every 100 hours of opera-
tion. Clean more often if necessary.
Inspect the area around the generator exhaust muf-
fler periodically and remove all grass, leaves, dirt,
etc. from this area.
Figure 3.4 — Clean Air Intake Screen
3.7 ENGINE SPARK PLUG
Clean engine spark plug and set gap to 0.030 inch
(0.76mm) every 100 hours of operation (Figure 3.5).
Clean by scraping or wire brushing and washing with
commercial solvent. DO NOT BLAST CLEAN SPARK
PLUG.
Figure 3.5 — Setting Gap on Spark Plug
Sparking can occur if wire terminal does not
fit firmly over spark plug terminal end. If nec-
essary, reform wire terminal to obtain a tight
fit.
3.8 FUEL FILTER
Remove and replace fuel filter (Figure 3.6) every 100
hours of operation or once each year, whichever
occurs first.
Figure 3.6 — Fuel Filter
Air Intake Screen
To Fuel Pump
Fuel Filter
Customer Fuel Connection

Generac Power Systems 00940-2 Specifications

General

Brand	Generac Power Systems
Model	00940-2
Category	Portable Generator
Language	English