EasyManuals Logo
Home>Generac Power Systems>Portable Generator>7000exl

Generac Power Systems 7000exl User Manual

Generac Power Systems 7000exl
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
Generac Portable Products 7000EXL Extended Life Generator
4
Your generator requires attachment of the negative battery
cable and is ready for use after it has been properly
serviced with the recommended oil and fuel.
IMPORTANT: Any attempt to run the unit before it has
been serviced with the recommended oil will result in an
engine failure.
Check that the following is included with your unit. If any
parts are missing or damaged, call the generator helpline at
1-800-270-1408.
Battery charge cables
Battery float charger
Extenda Panel™ cord
Generator and engine owner’s manuals
Locking 30 Amp plug
Three packets of fuel stabilizer
Two bottles of engine oil
CHECK BATTERY / ATTACH
NEGATIVE BATTERY
WIRE
The sealed battery on the generator is fully charged and
pre–installed except for the negative (black) battery cable.
To install:
Cut off tie wrap securing loose end of negative (black)
cable.
Remove nut and washer on the negative battery terminal.
Slide the negative battery cable over the screw on the
negative terminal (Figure 2).
Reattach washer and nut and tighten.
Verify that the connections to the battery and generator
are tight and secure.
Figure 2 — Negative Battery Connection
Positive battery cable
Screw
Negative
battery
cable
Washer
Nut

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Generac Power Systems 7000exl and is the answer not in the manual?

Generac Power Systems 7000exl Specifications

General IconGeneral
BrandGenerac Power Systems
Model7000exl
CategoryPortable Generator
LanguageEnglish

Related product manuals