4
ENGLISH
INTERMODO2 868
1. DESCRIPTION
The INTERMODO2 control board is a two-channel external receiver, which has an integrated decoding system. When a
channel is activated by radio control, the relevant N.O. relay contact closes by the methods described in chapter 5.
The selectable configurations are:
CH1= pulsed N.O. relay output
CH2= pulsed/fixed N.O relay output (selectable by DS1)
2. TECHNICAL SPECIFICATIONS
MODEL INTERMODO2 868
POWER SUPPLY (V) 12/24 ~
RECEPTION FREQUENCY (MHz) 868.35±0.2
ABSORBED CURRENT (A) 100 mA
SAVEABLE CODES 250
NUMBER OF CHANNELS 2
NUMBER OF RELAY OUTPUTS (N.O.)
N 1 pulsed (CH1)
N 1 pulsed/fixed (selectable) (CH2)
RELAY CONTACTS CAPACITY 0.5 A / 120 VA
PROTECTION CLASS IP 44
OPERATING AMBIENT TEMPERATURE (°C) -20 / +55
EXCLUSIVE USE gate opener
This product complies with Directive 99/05/EEC
Product notified in all E.C. countries
a
Preperforated facility for cable grippers
b
Cover
c
Facility for securing on DIN guide
d
Fittings for screw securing
e
Terminals for command output (N.O.)
f
Normally open (N.O.) relay contact
g
Signalling LEDs (ON= OUTPUT ACTIVE)
DL1=LED CH 1 DL2=LED CH2
h
Radio programming push-buttons
SW1=PUSH-BUTTON CH1 SW2=PUSH-BUTTON CH2
i
DS1: Selection dip-switch
j
Power supply terminal
k
Terminal for antenna
l
DL3: Mains ON LED ( ON = MAINS PRESENT )
a
Preperforated facility for cable grippers
b
Cover
c
Facility for securing on DIN guide
d
Fittings for screw securing
e
Terminals for command output (N.O.)
f
Normally open (N.O.) relay contact
g
Signalling LEDs (ON= OUTPUT ACTIVE)
DL1=LED CH 1 DL2=LED CH2
h
Radio programming push-buttons
SW1=PUSH-BUTTON CH1 SW2=PUSH-BUTTON CH2
i
DS1: Selection dip-switch
j
Power supply terminal
k
Terminal for antenna
l
DL3: Mains ON LED ( ON = MAINS PRESENT )
DS1 ON OFF
DIP SWITCH 1
OUTPUT
CHANNEL 2
FIXED
OUTPUT
CHANNEL 2
PULSED
DIP SWITCH 2 NOT USED NOT USED
DS1 ON OFF
DIP SWITCH 1
OUTPUT
CHANNEL 2
FIXED
OUTPUT
CHANNEL 2
PULSED
DIP SWITCH 2 NOT USED NOT USED
Fig. 1Fig. 1
To Next Page
Loading...
Need help?
General
