- 41 - BIOS Setup
Thefollowingeldsdisplayyourharddrivespecications.Ifyouwishtoentertheparametersmanually,
refer to the information on the hard drive.
Capacity Approximate capacity of the currently installed hard drive.
Cylinder Number of cylinders.
Head Number of heads.
Precomp Write precompensation cylinder.
Landing Zone Landing zone.
Sector Number of sectors.
Drive A
Allowsyoutoselectthetypeofoppydiskdriveinstalledinyoursystem.Ifyoudonotinstallaoppy
disk drive, set this item to None. Options are: None, 360K/5.25", 1.2M/5.25", 720K/3.5", 1.44M/3.5",
2.88M/3.5".
Floppy 3 Mode Support
Allowsyoutospecifywhethertheinstalled oppy disk drive is 3-mode oppy disk drive, a Japanese
standardoppydiskdrive.Optionsare:Disabled(default),DriveA.
Halt On
Allows you to determine whether the system will stop for an error during the POST.
All Errors Whenever the BIOS detects a non-fatal error the system boot will stop.
No Errors The system boot will not stop for any error.
All, But Keyboard The system boot will not stop for a keyboard error but stop for all other errors.
(Default)
All,ButDiskette Thesystembootwillnotstopforaoppydiskdriveerrorbutstopforallother
errors.
All,ButDisk/Key Thesystembootwillnotstopforakeyboardoraoppydiskdriveerrorbutit
will stop for all other errors.
Memory
Theseeldsareread-onlyandaredeterminedbytheBIOSPOST.
Base Memory Also called conventional memory. Typically, 640 KB will be reserved for the
MS-DOS operating system.
Extended Memory The amount of extended memory.