Programming a new wash program 46
Code 429159
Rev. 15/0717
7.5. INFO A6 mode
By using A6 Info mode, the external dosing signals pertaining to the A6(I/O2) board can be used to increase the
number of simultaneous doses or as a mode for binary based communication with a smart external unit (PLC or
similar).
See the examples of use in the appendices
Appendices showing examples of the use of the A6 Info mode can be found at the end of this manual.
7.5.1. External dosing signals used in INFO A6 mode
INFO A6 mode options
This communication mode adds the following possibilities:
Info A6 mode not used.
<<< Option programmed by default
Transfer of the load value
Allows the value of the linen load to be transferred via the outputs of the A6(I/O2) board. This load
value is transferred in kg regardless of whether the machine is configured to work in kg or lbs.
This option requires Load Detection to be activated in the menu. Modifiable values table. Similarly, it
may be worthwhile activating some of the following options from the same menu (see Chapter 10):
Proportional bath level.
Proportional dosing time.
Default value: Nominal washing machine load.
Transferring a numerical value
Enter a decimal numerical value (0-255) whose conversion to a binary base will activate the
corresponding output on the A6(I/O2) board. See Section 7.5.2 and the output activation table for the
A6(I/O2) board in Section 7.5.3.
Default value: 0.
To Next Page
Loading...
Need help?
General
