Go Power GP-IC-3000 User Manual

[page 28] | gpelectric.com
IN 1
AC Live from main panel
IN 2
AC Live from main panel
ACN-IN
AC Neutral from main panel
AC Inputs
AC Outputs
OUT 1
AC Live to sub panel
OUT 2
AC Live to sub panel
ACN-OUT
AC Neutral to sub panel
UNIT
ON/OFF
CHARGER
ON/OFF
SHORE POWER
UNIT READINGS
UNIT SETUP
REMOTE SETTINGS
Main Panel
Sub Panel
IN 1
AC Live from main panel
IN 2
AC Live from main panel
ACN-IN
AC Neutral from main panel
AC Inputs
AC Outputs
OUT 1
AC Live to sub panel
OUT 2
AC Live to sub panel
ACN-OUT
AC Neutral to sub panel
UNIT
ON/OFF
CHARGER
ON/OFF
SHORE POWER
UNIT READINGS
UNIT SETUP
REMOTE SETTINGS
Main Panel
Sub Panel
3.6.5 AC CONDUCTOR WIRING
Make sure the IC Series is fully disconnected from the battery bank and no AC power is connected to the
Inverter/Charger before commencing any AC wiring connections.
ACINPUTSWIRING(50ADualIN,DualOutConguration)
• Remove the AC cover plate.
• Route the wires: IN1 (Hot1), IN2 (Hot2), ACN-IN (neutral), and Ground from the main panel through the AC Input
strain relief clamp. Tighten the strain relief clamp securely on the wires. Always leave a little extra slack in the wiring.
• Connect the HOT1 wire (black) from the main panel to the Inverter/Chargers IN1 terminal. Connect the HOT2
wire (red) from the main panel to the Inverter/Charger’s IN2 terminal. Tighten the terminals securely. Note: To
use the Battery Charger, IN1 must always be connected to an AC Input.
• Connect the NEUTRAL (white) from the main panel to the Inverter/Chargers ACN-IN terminal. Tighten the terminal
securely.
AC OUTPUTS WIRING
• Route the wires (hot, neutral, and ground) from the sub panel through the AC INV. Output strain relief clamp.
Tighten the strain relief clamp securely on the wires. Always leave a little extra slack in the wiring.
• Connect the OUT1 wire (black) and OUT2 (red) from the Inverter/Charger to the sub panel. Tighten the terminals
securely.
• Connect the ACN-OUT Neutral out (white) from the Inverter/Charger to the sub panel. Tighten the terminal securely.
• To prevent possible damage to the case, always add additional external non-conductive strain relief when using
large diameter multi-conductor cables for AC inputs and AC outputs.
INSTALLATION

Go Power GP-IC-3000 Specifications

General

Brand	Go Power
Model	GP-IC-3000
Category	Battery Charger
Language	English