ASSEMBLING YOUR SCOOTER
Unfold the scooter by
pressing down on the rear
fender. Separate the folding
hook and fender buckle, then
lift the tiller upright.
The brake line will be put
into the crevasse on the bot-
tom of the brake piece on
the handle bar
TOOLS YOU’LL NEED: 4 mm Allen Key Wrench (both included).
Press down brake lever to be
able to insert the pin on the
brake line.
Lower brake line pin into hole
in the brake lever.
Pull brake cable into the
crevasse to the left.
Use the Allen wrench to
loosen the screws located at
the hook and detach. Once
you’ve remove the hook and
screws, make sure to remove
the plug inside of the top of
the tiller.
To Next Page
Loading...
Need help?
General
