Cleanup
22 3A3212C
Cleanup
Cleaning the sprayer after each use results in
a trouble free start up the next time the
sprayer is used.
Cleaning from a Pail
(Stand Models Only)
Pail flushing only works with models that
have a suction tube.
• For long term storage refer to Storage,
page 29.
• See Cleaning Fluid Compatibility,
page 30 and Static Grounding
Instructions, page 31.
1. Perform Pressure Relief Procedure,
page 13.
2. Remove tip guard and spray tip.
3. Remove suction tube and drain tube
from paint, wipe excess paint off out-
side.
4. Separate drain tube (smaller) from suc-
tion tube (larger).
5. Place empty waste and flushing fluid
pails side by side.
6. Place suction tube in flushing fluid. Use
water for water based paint and mineral
spirits or compatible oil-based flushing
solvent for oil-based paint. Place drain
tube in waste pail.
7. Turn pressure control knob to the
Prime/Clean setting.
8. Place Prime/Spray valve in PRIME
position.
ti25197a
ti27495a
ti27135a
To Next Page
Loading...
Need help?
General
