GB - 19
SERVICING THE BATTERY
NOTE: Unit comes equipped with a
maintenance-free battery that requires no
regular maintenance except cleaning
terminals.
Battery Removal and Installation
(Figure 20)
Remove
NOTE: Tag and mark wires prior to
disconnecting.
1. Remove detent pin (item 2) and tip seat
(item 1) forward.
2. Disconnect operator presence switch
wires (item 3) and remove seat (item 1)
from seat retainer slots (item 4).
3. Disconnect negative (–) cable (item 9)
first then positive (+) cable (item 10).
4. Remove battery hold down bracket
(item 5) and cross brace (item 7).
5. Remove battery (item 6) from unit.
Install
1. Install battery (item 6) on unit.
2. Install cross brace (item 7) and battery
hold down bracket (item 5).
3. Connect positive (+) cable (item 10) first,
than negative (–) cable (item 9).
4. Apply petroleum jelly or dielectric grease
to battery cable ends and terminals.
5. Install seat (item 1), in seat retainer slots
(item 4) and connect operator presence
switch wires (item 3).
6. Put seat (item 1) down and install detent
pin (item 2).
WARNING: Battery posts, terminals
and related accessories contain lead
and lead compounds, chemicals
known to the State of California to
cause cancer and reproductive harm.
Wash hands after handling.
OE0028
4
11
3
10
6
9
8
5
1
2
7
Figure 20
1. Seat
2. Detent Pin
3. Operator Presence
Switch Wires
4. Seat Retainer Slot
5. Battery Hold Down
Bracket
6. Battery
7. Cross Brace
8. Negative (–) Terminal
9. Negative (–) Cable
10. Positive (+) Cable
11. Positive (+) Terminal
To Next Page
Loading...
Need help?
General
